Brammo Enertia Discussion > Brammo Enertia Servicing

SERVICE REQ'D H34

(1/2) > >>

skimbrie:
My 2010 Enertia v1.1 is showing the subject error message on boot up and won't go into drive mode. Searched and can't find any advise.

Help please?

Thanks,
-Scott K.

sunchaser:
Hello and welcome to the forum. 

The Enertia owner's manual has a list of error codes and descriptions.  I looked up H34 and the manual lists it as:

SERVICE REQ'D H34 Discharge “pre-Charge” error (Disable Drive)

You can download a copy of the manual PDF from this link:

https://scf99fe700a0cb239.jimcontent.com/download/version/1522676017/module/12211152226/name/Brammo%20Enertia%20Owners%20Manual.pdf

Unfortunately I don't have any additional information beyond the description.  Hopefully someone else here on the forum can assist.

09enertia:
I have the same error message H34 now. Did you ever solve it?

sunchaser:
I looked this error code up in the Enertia service manual (available for download somewhere in the wiki) and the description is as follows:

Dash Warning Message      Warning/Error Desription             Source

SERVICE REQ'D H34             Discharge "pre-Charge error             Harness


I'm not sure what the manual is referring when mentioning "harness" as the source.  Possibly an issue with the wiring?  The Enertia Basic wiring diagram is available on the wiki as well.

Good luck.

09enertia:
Hey! Thank you for the info on the code. Yeah, I think harness means wiring. I was having a problem with the throttle over-accelerating just before the warning code, so maybe it’s related to that.  Do you know if anyone has the software to run a diagnostic or how I could get it? Also, do you know how to reset/clear the code? I tried pushing the button inside the bike under the start button but it didn’t clear the code. Thank you.

Navigation

[0] Message Index

[#] Next page