Recent Posts

Pages: 1 2 [3] 4 5 ... 10
21
Off Topic / Re: HadesOmega Moto Racing Light Bee Winter 24 Build VLOGs
« Last post by HadesOmega on April 14, 2024, 05:10:57 PM »
KO F-Spec Controller Review



EBMX X-9000 vs KO F-Spec Controller Comparison



Uninstalling the KO F-Spec Controller
22
Off Topic / Re: The Hydrogen Highway
« Last post by HadesOmega on April 14, 2024, 05:09:49 PM »
I heard that EVs are on the decline lately and hybrids are what everyone wants now.  Hydrogen still not there yet we're all waiting for that magic battery or magic green hydrogen.
23
Brammo Enertia Servicing / Re: Recharged and balanced six dead batteries
« Last post by Epicurus on April 09, 2024, 07:57:44 PM »
What kind of trickle charger did you use?
24
Brammo Enertia / Re: 2011 Enertia Basic Not Powering Up During Charge-Need Cables
« Last post by sunchaser on April 08, 2024, 06:10:29 PM »
Trying once again for a successful reply.

The bike doesn't power up at all?  If that's the case it's possible the batteries have self-discharged to the point where the overall voltage is too low.  Can you check the individual battery voltages and report back with the results?

I learned the hard way that it isn't a good idea to let these bikes sit for long periods of time without checking the SoC every two to three weeks.  Even that can be misleading.  It's actually better to also check the high and low cell group voltages as well.  While the overall SoC may be fine, a weak battery may have individual cell groups with low voltage that won't be noticed without going into the secondary menu of the charging screen.
25
Brammo Enertia / Re: 2011 Enertia Basic Not Powering Up During Charge-Need Cables
« Last post by sunchaser on April 08, 2024, 06:03:34 PM »
Looks like my previous reply got cut off.

The bike doesn
26
Brammo Enertia / Re: 2011 Enertia Basic Not Powering Up During Charge-Need Cables
« Last post by sunchaser on April 08, 2024, 05:55:09 PM »
Sorry to hear about your Enertia. It
27
Off Topic / Re: The Hydrogen Highway
« Last post by Richard230 on April 08, 2024, 08:03:16 AM »

The hydrogen highway is back in the news again: An long article written by Toss Woody, published by Bloomberg, titled "Navigating California's hydrogen highway with $200 and few stations" was in my newspaper today.  The former long-time chief climate regulator used to drive a Toyota Mirai, but now drives a BEV Ford Mustang Mach E, which gets the same 300 mile range as her Mirai used to.

The article goes on to say: "Despite billions of dollars of investment, fuel cell cars in the U.S. are disappearing in the rearview mirror, overtaken by battery-electric models and stalled by hydrogen shortages and soaring fuel prices. Last year, drivers bought just 3,143 hydrogen cars in California - the only state that sells them - compared with 380,000 EVs."

It then goes on to say how last year Shell declined a $41 million state grant to build 50 stations in the state and that California scaled back its 200 station target to 130 stations by 2027. In February, Shell shuttered six of its seven retail hydrogen stations in the state.

A total of 66 H2 stations in California remain, but 12 have been offline for more than 30 days and others sporadically shut down due to supply shortages or equipment problems. Whereas there are currently 105,000 EV charging stations in the state (the article didn't mention how many of those are working).

Complaints about fuel prices are common. Filling up an H2 powered car can cost about $200 - the equivalent of paying $14.60 a gallon of gas.

So nothing new. Apparently the best use for hydrogen vehicles continues to be to power long-haul semi-tractor trucks.
Report to Moderator
28
Brammo Enertia / 2011 Enertia Basic Not Powering Up During Charge-Need Cables
« Last post by Epicurus on April 08, 2024, 05:43:56 AM »
Hello all!

My Enertia wasn't charging last summer and now I can't get it to turn on at all. I recently made the dash Y-cable to do diagnostics, but I need to get the batteries to hold charge first. Does anyone have info on this two piece battery communication cable? Where to buy our a technical drawing?

See attached picture.
29
Brammo Enertia / Re: 3D CAD file Enertia
« Last post by Epicurus on April 07, 2024, 05:52:16 PM »
I made a replacement pair of rear blinkers for my 2011. I have attached the 3D model I made.
30
Bikes For Sale Or Auction / Re: Battery modules on ebay
« Last post by charlielopez on April 06, 2024, 06:04:41 PM »
Hey, that's a great find! I am really looking at learning to restore these batteries. I posted on another thread, just have had no leads . . .
Any chance you guys have seen the Battery Diagnostic Cable (PV-51900) for that Brammo Power Module Series?
Pages: 1 2 [3] 4 5 ... 10