Author Topic: Tail assembly loose: losing bolts  (Read 1407 times)

FrankH

  • Empulse Guru
  • ****
  • Posts: 142
  • First Enertia+ in the Netherlands!
    • View Profile
Tail assembly loose: losing bolts
« on: March 15, 2014, 08:32:36 AM »
Yesterday I noticed that the rear end of my Enertia Plus was wobbly. On closer inspection I saw that a bolt is missing. In the time that I own the bike (a year and three months) this is the second time a bolt's fallen out.

I've already asked my dealer about the size of replacement bolts, but with @shinysideup's scary story about his tail nearly falling off in mind, I think another warning can't hurt: check to see if these bolts are still fastened regularly!

There's four of them; two on each side under the taillight. Arrows mark the ones that had gone missing on mine. The bottom one I could replace with something I had in my toolchest, but the one that's missing now must be shorter and you'd need some L-shaped wrench to screw it in.
« Last Edit: March 15, 2014, 08:46:52 AM by FrankH »

Richard230

  • Brammovangelist
  • *****
  • Posts: 2519
    • View Profile
Re: Tail assembly loose: losing bolts
« Reply #1 on: March 15, 2014, 09:39:08 AM »
Don't forget to use blue Locktite when replacing the bolts.
current bikes: 2018 16.6 kWh Zero S, 2011 Royal Enfield Bullet 500 Classic, 2009 BMW F650GS, 2007 BMW R1200R, 2005 Triumph T-100 Bonneville, 2002 Yamaha FZ1 and a 1978 Honda Kick 'N Go Senior.

Shinysideup

  • Brammovangelist
  • *****
  • Posts: 1423
    • View Profile
Re: Tail assembly loose: losing bolts
« Reply #2 on: March 15, 2014, 04:10:23 PM »
+1 on Loctite. 

Be sure to clean the bolt and threaded hole well with brake parts cleaner to remove all traces of oil and dirt before applying the thread locker.