Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - KaFr

Pages: [1] 2 3 ... 21
1
Victory Empulse / Re: oil leaking from electric motor
« on: March 16, 2024, 08:42:25 PM »
Hi, I have a few questions:
Did you find out what was the cause of the damaged gasket?
Was it mechanical damage (locking pin in groove) or chemical damage (old or inappropriate type of transmission oil)?
Why did you choose the 10W40 specification, which has a higher viscosity than the one recommended by Victory (10W30)?
Won't it have an effect on higher losses in the gearbox and thus a shorter range?
Thanks a lot for answer.

2
Bikes For Sale Or Auction / Re: Brammo empulse R 2014 Yellow NL
« on: March 01, 2024, 04:15:25 PM »
I would recommend you to buy the second Brammo Empulse as well. It is a very rare bike and spare parts are very difficult to find.

3
Victory Empulse / Re: oil leaking from electric motor
« on: March 01, 2024, 04:10:32 PM »
You are doing a very good job, Korbin.
It is useful for all of us!

4
Brammo Empulse / Re: B40 error tackling
« on: October 06, 2023, 04:22:37 AM »
Quote from: acceler on October 04, 2023, 06:37:06 PM
Balancing the modules while its open since bike was stitting at 12% for the pass year dead. They started at 14.08v

Hi acceler,
when I look at the photo of you balancing the battery cells that are removed from the package, I have one important note:

When you charge the cells from 12 to 100%, they will increase their volume a lot and it will be difficult to put them back in the outer packaging. You'll have to clamp them down like Corbin did. A better option is to discharge the cells after balancing them again to reduce their volume, put them in the package and then charge them again.

It is also very important for this type and chemistry of cells that they have no possibility of movement in the package. Otherwise, cell casing leaks around the electrodes, which is the cause of chemical leakage.

5
Brammo Enertia Plus / Re: Brammo Enertia Plus dosn't charge after winter
« on: June 16, 2023, 03:14:01 AM »
Hello Bernie,
did you receive my contact info by PM?
I would like to make an arrangement with you about the suitcases and keys.
Thank you
Karel

6
Brammo Enertia / Re: Convert to Belt Drive? Can it be done?
« on: June 16, 2023, 03:09:15 AM »
Hi Oliver,
I am in contact with the guy from Germany who converted his Enertia to a belt drive. If you write me your contact, I can pass it on to him. The entire conversion cost about 1200 Euro.
Cheers
Karel

7
Brammo Enertia / Re: My Enertia turns "On" but won't "Go"
« on: June 16, 2023, 03:05:24 AM »
Hi Gerry, thank you.
It is a dc-dc converter that is soldered directly on the VCU board.
It's a Murata NTE0512MC.

https://power.sager.com/nte0512mc-1501720.html

I don't think it can be replaced with another power supply.
I have another spare VCU where the same converter is burnt.
My friend is going to replace it with a new one and I'm going to hope it helps to get my bike working again :)

Cheers
Karel

8
Brammo Empulse / Re: NEW BATTERY FOR EMPULSE
« on: June 16, 2023, 02:54:31 AM »
It looks like module #7 has about 10% lower SoC than the other modules.
Is it possible to ballance it, for example by longer charging?

9
Brammo Enertia / Re: My Enertia turns "On" but won't "Go"
« on: June 08, 2023, 08:39:49 AM »
I have the same problem now with my Enertia+  :'(

When I want to put the bike into ride mode by pressing the start button, nothing happens. The contactor does not close and the control diode on the Sevcon motor controller does not light up. I found out that there was a fault somewhere inside the control unit. When I connected it to another working bike, same fault appeared.

Could the DC-DC converter on the VCU board be broken even though it looks fine visually? I also have a problem with the parking lights sometimes not turning on in the park key position, but I don't know if that's related. Also occasionally in the past there was a D4 error and the bike stopped running. After a reboot it worked again.

10
Brammo Enertia Plus / Re: Brammo Enertia Plus dosn't charge after winter
« on: June 04, 2023, 03:28:01 PM »
Hi Bernie,
this is really great news!
I am sending you my contact information.
Cheers
Karel

11
Brammo Enertia Plus / Re: Brammo Enertia Plus dosn't charge after winter
« on: June 02, 2023, 07:19:41 AM »
Hi Bernie,
thank you for your answer.
Can I buy your Givi Suitcases?
I sent you PM.
Cheers
K.

12
Bikes For Sale Or Auction / Victory Empulse TT upper battery module
« on: April 18, 2023, 02:29:26 PM »
It's the upper module from the Victory Empulse TT after the engine caught fire.

https://www.ebay.com/itm/255196151699

13
Brammo Enertia / Re: 2010 enertia how to get more torque ?
« on: April 18, 2023, 02:10:24 PM »
Rear sprocket with more teeth than original?

14
Bikes For Sale Or Auction / Re: 2013 Brammo Empulse project or parts bike
« on: April 13, 2023, 05:38:44 AM »
Can I just buy some spare parts from the bike, like the DC-DC converter?

15
Bikes For Sale Or Auction / Re: Brammo enertia
« on: March 29, 2023, 03:57:17 AM »
I would love to get all those nice carbon parts, but I don't know how to contact the seller.
Could you please help me? :)

Pages: [1] 2 3 ... 21