Brammo Enertia Discussion > Brammo Enertia Mods

Reflective wheel tape mod

<< < (5/5)

Shinysideup:

--- Quote from: jazz999 on May 14, 2016, 05:04:47 PM ---Sorry but I am still confused on how and where you wired the fuse panel on your bike. thanks

--- End quote ---

First find the 12V tap which is a wire with a white connector that comes out from under the "gas tank" near the front right of the bike, after removing the plastic radiator panel at the very front and the front right panel.

I cut the connector off connected an extension 2-conductor wire by using solder and shrink tubing.

I made the distal end of that wire terminate in two ring connectors which I fastened to the fuse block, after verifying their polarity with my multi-meter.

Then I fastened the fuse block to something handy (can't remember what), with zip ties (plastic wire tie wraps). I tucked it in a handy space just above the radiator where it's relatively out of the weather behind the front plastic panel.

Hope that helps...

Navigation

[0] Message Index

[*] Previous page