Brammo Enertia Discussion > Brammo Enertia Mods
Roan's mods
Roan:
With this mod I can charge my Enertia without removing the seat. I shortened a C19-C20 power cord and mounted it underneath the seat. A vinyl pull tab cap will prevent the connector collecting dirt or moisture.
I used a plastic V form and attached the connector with two blind nails. This sticks with double sided foam tape at the end of the rear light. I can also drill two holes for blind nails in case the tape doesn't last.
A second power cord I leave under the seat and the other one stays at home for easy use.
Roan:
Job done. I received the pull tab cap and took some beter pictures:
Roan:
I replaced the H4 headlight bulb by a HID kit bi-xenon light. The ballast and connectors just fit in the headlight. It uses 35 watt instead of the 55 watt standard bulb. But most important, the brightness has increased and delivers approximately 3500 lumens. Much more than a led bulb could deliver.
Now the surprising part: total costs were just $ 20
Brammofan:
Excellent! Can you tell us your source for the parts?
Roan:
I bought the HID kit and H4 connector eBay. The connectors are $3,25 (2 pc's) and bi-xenon kit costs $ 15,99. Aussi dollars.
You could do without the connector and solder the wires, but now I can easily change it back.
The illumination is very bright!
http://www.ebay.de/itm/231025311409?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1423.l2648
http://www.ebay.de/itm/171130180853?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1423.l2649
Navigation
[0] Message Index
[#] Next page
Go to full version