Author Topic: System Fault S60  (Read 3625 times)

Leander

  • Brammovangelist
  • *****
  • Posts: 206
    • View Profile
    • Email
System Fault S60
« on: June 29, 2018, 10:02:15 AM »
any one had this before?

manual says motor too cold.

but today it is 32C outside.

motor temp reads 163C ish.

when I touched the motor it was just warm I think about 55C or so.
which is normal.

Leander

  • Brammovangelist
  • *****
  • Posts: 206
    • View Profile
    • Email
Re: System Fault S60
« Reply #1 on: July 01, 2018, 06:32:24 AM »
small update,

Turns out the coolant level was low, so a lot of noise from the pump.
filled it up again and let the air out.
pump sounds normal again.

still got the S60 code and a presieved motor temp around 165C from start up.
so water pumps kicks in inmediately.

is there a way to reset the bike that's not just turning is off and on again?

Leander

  • Brammovangelist
  • *****
  • Posts: 206
    • View Profile
    • Email
Re: System Fault S60
« Reply #2 on: July 02, 2018, 04:46:03 PM »
I checked the log files today.

motortemp was showing -50 or so

different from the display that shows 150c or so

probably a motor termister died or a cable defect somewhere

no other problems exept for the odd 1 second A6 fault about the AIM

drove to work and back that's 140km no problems exept for the S60 code and blinking warning symbol irritating in the display.

Leander

  • Brammovangelist
  • *****
  • Posts: 206
    • View Profile
    • Email
Re: System Fault S60
« Reply #3 on: July 09, 2018, 04:20:03 PM »
found the sensor that is faulty
termister inside the motor :o

I don't think I can't fix that, so I'm going to try to fool the sevcon with a 30Kohm resistor so it thinks the motor temp is at 25c
if it's a Omega 44008 at least.


Leander

  • Brammovangelist
  • *****
  • Posts: 206
    • View Profile
    • Email
Re: System Fault S60
« Reply #4 on: July 25, 2018, 02:42:41 PM »
Confirmed that the sensor is faulty.

I disconnected the sensor on the motor and put a new KTY84 on the connector to the motorcontroller to test.

Now it shows an  almost normal motor temp on the display and the S60 error has gone.;D
The only thing left is to find a good place to put the new sensor so it will get the most accurate temps.

HadesOmega

  • Brammovangelist
  • *****
  • Posts: 907
  • #139
    • View Profile
    • Email
Re: System Fault S60
« Reply #5 on: July 25, 2018, 03:16:39 PM »
Do you have any pictures of this sensor?  For future reference?
2016 Victory Empulse TT - #139

Leander

  • Brammovangelist
  • *****
  • Posts: 206
    • View Profile
    • Email
Re: System Fault S60
« Reply #6 on: July 26, 2018, 04:31:58 PM »
As soon as I will work on it I wiil take the pictures.