General > Welcome Forum

Pit Bull Front Stand

(1/1)

Ultratoad:
Did anyone ever figure out whether a Pit Bull front stand could be used with the Empulse TT ????

HadesOmega:
Hmm not sure but I use an old T-Rex front stand on mine.  Didn't seem very secure though but it would rest on the caliper mounts. 

Ultratoad:
I was hoping to go from the steering head....  Pit Bull does not make a pin narrow enough to fit the Empulse TT steering shaft hollow....  AND I am concerned that having one turned down to fit might be unsafe....  Just wondering if anybody had found an option....

KaFr:
It depends on what purpose you need to lift the front of the motorcycle. If you are removing the front wheel, it is best to support the sliding protectors (or M10 screws screwed into the threaded holes) on the side of the motorcycle's main frame with two side stands. Another option that occurred to me is to lift the front of the motorcycle with a pulley attached to the ceiling, whose hook can be attached, for example, to the handlebar tube.

Navigation

[0] Message Index